ATC MBrick (Modular Brick) is an Industrial IoT platform that bridging the gap between PLC and specific domain controllers. The platform are designed to be very modular in order to be used at smart cities, precision agriculture, aquaculture industry, greenhouse applications, building management systems and destributed process control applications.

prev next

ATC MBrick Main Board

  • Microcontroller AT91SAM3X8E
  • Architecture ARM Cortex- M3
  • Operating Voltage 3.3 V
  • Flash memory 512 KB
  • SRAM 96 KB (two banks: 64KB and 32KB)
  • Clock Speed 84 MHz
  • 1 CPU \ Communication Interface Slot
  • 1 Power Supply Slot
  • 9 Analog Input Slots
  • 2 Analog Output Slots
  • 3 Communication Slots
  • RTC with Battery Backup
  • EEPROM 2KBIT for comfiguration Settings
  • USB connectors for Power Bank supply & charging
  • Onboard power requlator for 3.3V
  • BrickOS for sensor plug and play operation.
  • PCB Size 200 x 7.2 mm

DC Input 24-48V Power Supply Module

  • Output Current @ 5V-2A

Ethernet Communication Module

  • Support 10/100 MBit
  • 8 Concurrent connections
  • Supports EXModbus TCP Protocol
  • Supports BrickLink TCP Protocol

Support Files:

0-5V Analog Input Module

  • Can be installed on Slots 1 to 9

0-10V Analog Input Module

  • Can be installed on Slots 1 to 9

0-20 mA Analog Input Module

  • Can be installed on Slots 1 to 9
  • Max operating voltage up to 30V DC

2 Channel Opto Digital Input

  • Can be installed on Slots 1 to 14
  • Input voltage 0-30VDC

2 Channel Solid State Relay Module

  • Can be installed on Slots 1 to 14
  • Each channel can drive up to 48V AC\DC 100 mA

One-Wire Interface Module

  • Can be installed on Slots 1 to 14
  • Supported Sensors by BrickOS :
    • DHT 11
    • DHT 21
    • DHT 22
    • DS18B20

CT Module

  • Can be installed on Slot 1 to 14
  • Non-invasive AC current sensor (30A max)
  • Non-invasive AC current sensor (100A max)

ATC MBrick Configurator Software

With MBrick Configurator you can:

  • Make of line configuration of the Main Board.
  • Configure analog channels units, scales and descriptions.
  • Configure CPU\Configuration Modules (IP address, protocols etc).
  • Update the BrickOS firmware.
  • Set the Main Board RTC Clock.
  • Online monitoring of Slot Modules.


Support Files: